Brushless Esc V2.3 Manual ✦ Works 100%

Remember: Ensure your V2.3 is mounted in an airflow path (drone arms, boat hatch vent, car chassis cutout). If it exceeds 70°C (158°F) after five minutes of running, you need a higher amp ESC or a smaller propeller/pinion gear.

| Menu # | Beep Pattern | Parameter | Options (Move throttle up/down, then save) | | :--- | :--- | :--- | :--- | | 1 | 1 short beep | Brake Type | 1 Beep=Off (Default) / 2 Beeps=Soft / 3 Beeps=Hard | | 2 | 2 short beeps | Battery Type | 1 Beep=LiPo (Default) / 2 Beeps=NiMH | | 3 | 3 short beeps | Cutoff Voltage (Low Voltage Protection) | 1 Beep=Low (2.8V/Cell) / 2 Beeps=Med (3.0V) / 3 Beeps=High (3.2V) | | 4 | 4 short beeps | Timing Advance | 1 Beep=Low (For 2-pole motors) / 2 Beeps=Med (Most outrunners) / 3 Beeps=High (High RPM) | | 5 | 5 short beeps | Start Mode (Punch) | 1 Beep=Soft / 2 Beeps=Normal (Default) / 3 Beeps=Aggressive | | 6 | 1 long beep | PWM Frequency | 1 Beep=8kHz (Default) / 2 Beeps=16kHz | | 7 | 1 long+1 short | Motor Rotation (Locked) | Use wire swap instead | brushless esc v2.3 manual

Save this manual. Bookmark the beep codes. And enjoy the smooth, efficient power of brushless RC. Disclaimer: Always wear eye protection when testing brushless motors at full throttle. The author is not responsible for damage caused by incorrect polarity or over-voltage. Remember: Ensure your V2